User Manuals · Request a Service · Request a Quote · Security Tips. Call us now on DSC – PC User Manual · DSC – PC User Manual. Page 1. Page 2. Page 3. Page 4. Page 5. Page 6. Page 7. Page 8. Page 9. Page Page Page Page Page Page Index of /manuals/DSC/Intrusion Panels/PC Parent Directory · LED · PC Spanish User · PC User
|Published (Last):||27 November 2014|
|PDF File Size:||6.21 Mb|
|ePub File Size:||3.16 Mb|
|Price:||Free* [*Free Regsitration Required]|
Enter text from picture: An immediate fire alarm signal and transmission is generated by holding down the. Page of 14 Go. User’s Programming Commands To review: Comments to this Manuals Your Name. By pressing ‘print’ button you will print only current page.
The Canadian Department of Communications label identifies certified equipment. Comments to this Manuals Your Name.
DSC PC3000 Instruction Manual Page 6
Page 34 PC Version 7. Zones cannot be programmed for fast response – Do not use fast response devices on these zones.
In sections  through , do not enter any data in sections that are not used. Also See for PC Instruction manual – 15 pages. Wait for 10 seconds. Printer The printer must be capable of serial communication RS- Section  in the panel must be programmed to enable the Don’t have an account? Got it, continue to print.
DSC PC3000 Instruction Manual Page 5
The keypad buzzer will not sound for AC failure until there is also a low. Don’t show me this message again. DO NOT connect multiple keypads on the same loop.
Page 38 PC Version 7. If zone light is on that code can be used to bypass.
Got it, continue to print. Terminal Connections switch to ground.
The test transmission is sent to  Sescoa super speed the monitoring station to confirm that the communication link  Not used Each input must be terminated with a 1K an extra keypad temporarily at the panel during power up ohm E. Don’t manuual an account?
If the smoke has. Manjal resetting a fire alarm signal. Page 44 R Enter the master code to entries that are as straight forward as dialing a telephone arm or disarm the panel.
Add to my manuals Add.
Index of /manuals/DSC/Intrusion Panels/PC
Page 33 PC Version 7. After the exit delay has expired, an open on the zone will cause the entry Disarming with Access Codes 9 to 16 delay time to start. Restoral Reporting Codes Zones 9 To 16  Restoral Reporting Codes  Reporting Dwc for Closing Zones 9 to 16 Arming with Access Codes 1 to 8 These reporting codes are used by the communicator to The reporting codes in sections  to  are used to transmit a zone restoral for zones 9 to Zone Light 1 to Group A.
If zone light is on, the zone can be Zone Light 2 bypassed using the [Q]  command.