View and Download Dell Precision m90 user manual online. mobile workstation. Precision m90 Laptop pdf manual Laptop Dell Precision M90 Service Manual. Dell Precision™ M90 Mobile Workstation Service Manual 1 II 1 |svstem Components || voofer | loptical Drive ||USB Port Board | | Drive ||Proces ^l- Coolinq. [title|Dell Precision M90 Repair] [summary_image|] Additional Resources: Service PDF Dell Precision M90 troubleshooting, repair, and service manuals.
|Country:||Trinidad & Tobago|
|Published (Last):||28 June 2014|
|PDF File Size:||15.96 Mb|
|ePub File Size:||9.99 Mb|
|Price:||Free* [*Free Regsitration Required]|
Then use your fingers to release the snaps around the rest of the bezel and lift it away from the display panel.
Shut down the operating system: Reroute the display cable kanual the cable channel. If a memory module is not installed properly, the computer does not boot. Turn the computer top-side up and disconnect the touch-pad connector from the system board.
Back to Contents Page. Use your fingers to separate the bezel from the display back cover by pulling the lower-right corner of the bezel down toward the bottom edge A of the display assembly to clear the tab on the bottom of the lower-right corner. Notes, Notices, and Cautions. Use firm and even pressure to slide the drive into place.
Dell Precision M90 Parts
Tighten the captive screw that attaches the precisuon ground wire to the display back cover. Only products approved for use in your portable computer may be installed. Information in this document is subject to change without notice. Turn the computer upside-down and remove the two M3 x 3-mm screws. If you feel resistance, check the connectors and realign the card.
Dell Precision M90 Laptop Replacement Parts |
Failure to do so may cause system damage. Insert a screwdriver into the indentation for the device security screw, and push the notch on the metal tab to release the drive from the bay. Repeat step 6 for the lower-left corner of the bezel.
Disconnect the LED board connector. Align the pin-1 corner of the processor module with the pin-1 corner of the ZIF socket, and manula the processor module.
Loosen in consecutive order the four captive screws, labeled manyal through “4,” that secure the processor thermal-cooling assembly to the system board. For a complete list of abbreviations and acronyms, see “Glossary” in the User’s Guide.
Back to Contents Page To ensure maximum cooling for the processor, do not touch the heat transfer areas on the processor thermal-cooling assembly.
Dell Precision M90 instruction manual and user guide
To help prevent damage to the system board, remove the main battery before working inside the computer. Returning a Hard Drive to Dell Return your old hard drive to Dell in its original or comparable foam packaging. Align the notch in the module edge connector with the tab in the connector slot. Failure to do so may cause system damage. Unless otherwise noted, each procedure assumes that the following conditions exist: Replace the Mini-Card cover.
Slide servicd battery-bay latch release on the bottom of the computer and remove the battery from the bay. Remove the four M2 x 3-mm screws that attach the ExpressCard cage to the top of the hard drive bay.
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network srevice. The oils in your skin reduce the heat transfer capability of the thermal pads. Recommended Tools The procedures in this document may require the following tools: Insert the latch assembly into the channel on the computer base, and press it into place.
The ZIF-socket cam screw secures the processor to the system board. To print the manual completely, please, download it. Install the replacement battery: