BRC1D52 MANUAL PDF

Installation manual. 1. The kit includes the following parts: 1. Remove the upper part of remote controller (Refer to figure 1). Insert a minus screwdriver into the. this operation manual before using the air conditioner. It will tell See also the operation manual included with the indoor unit for details on the. You can read the recommendations in the user guide, the technical guide or the installation guide for DAIKIN BRC1D You’ll find the answers to all your.

Author: Kazrajar Togar
Country: Sao Tome and Principe
Language: English (Spanish)
Genre: Life
Published (Last): 20 October 2005
Pages: 189
PDF File Size: 9.20 Mb
ePub File Size: 20.4 Mb
ISBN: 137-7-48493-949-6
Downloads: 81276
Price: Free* [*Free Regsitration Required]
Uploader: Tygoran

This operation is unnecessary when setting by group.

BRC1D52 | Daikin

P1 and P2 do not have polarity. Permission level function 6. Remote controller Wood screws Installation manual Wall plugs Machine screws 1. If required, you can limit the user action by restricting the number of operable buttons. The PC board is mounted in the upper part of the remote controller. During this time the remote controller can not be operated. Set the remote controller before turning the power supply on.

  30RB AQUASNAP PDF

Long life filter Msnual. Refer to the instruction manual grc1d52 each optional accessory.

Manual BRC1D52 Daikin

Refer to figure 8. Do not make any settings not given in the table. Refer to the chapter “Field settings”. Remove the upper part of remote controller Refer to figure 1 Insert a minus screwdriver into the slots 1 in the lower part of the remote controller 2 placesand remove the upper part of the remote controller. Do not directly touch the PC board with your hand. Refer to figure 5. Setting is carried out in the group mode, however, if the mode number inside the parentheses is selected, indoor units can also be set individually.

Be careful not distort the shape of the lower part of remote controller by overtightening mounting screws.

Reattach the upper part of the remote controller Be careful not to pinch the wiring when attaching. Connect the terminals on top of the upper part of the remote controller P1, P2and the terminals brc1s52 the indoor unit P1, P2.

It’s a community-based project which helps to repair anything.

Refer to figure 4: NOTE When wiring, run the wiring away from the power supply wiring in order to avoid receiving electric noise external noise. The switch box and wiring for connection are not included.

  IRF 4410 PDF

Change setting when ultra-long filter brc15d2 installed 2 Thermostat sensor in remote controller 3 Spacing time of display time to clean air filter count setting for when the filter sign is not to be displayed 0 15 25 Approx. Not displayed if the indoor unit is not equipped with that function.

Be careful not to damage the board with the minus screwdriver.

The kit includes the following parts: First begin fitting from the clips at the bottom. Wire the indoor unit 1 Refer to figure 6 NOTE indoor unit 2 lower part of the remote controller 3 upper part of the remote controller 4 wired from the rear 5 wired from the top 6 mznual the part for the wiring to pass through with nippers, etc.